T
TkM
Guest
I have had the extender for two weeks now. It was delivered promptly and discreetly, as promised.
I must report that the past two weeks have been painful and frustrating.
It seems these devices are made for men that are circumcised, probably due to them being designed in a country where the majority of the males have been circumcised, which I don't think is the case in the UK.
It is extremely difficult to pull back the foreskin, stretch my penis and attempt to noose my bell-end, as is the method suggested in the manual. At least four pairs of hands are required for this exercise.
The foreskin inevitably creeps back and gets in the way, it is impossible to hold it back while tightening the noose.
I have learned the hard way that if you trap the foreskin under the noose and tighten you are in for an excruciating experience and some unsightly swelling that takes days to go down!
On the occasions that I do manage to get the positioning of the noose just right, without trapping any foreskin, unfortunately it is not long before the head slips out, painfully.
The noose is fastened tightly enough and the device is not over tensioned.
I have used the foam padding that comes with the kit. It does help to make it more comfortable but makes the device even more fiddly to use, instead of four pairs of hands six are now needed. It also does not last very long, in the two weeks I have had mine it is nearly all used up.
In the two weeks I have been using it I have noticed no gains unless you want to count the swelling caused by trapped skin!
I understand that two weeks might be too early to expect results.
Can anybody offer reasonable suggestions on how to make this device easier to put on, without trapping foreskin?
How can I stop my penis head from slipping out after only wearing it for a short time?
I must report that the past two weeks have been painful and frustrating.
It seems these devices are made for men that are circumcised, probably due to them being designed in a country where the majority of the males have been circumcised, which I don't think is the case in the UK.
It is extremely difficult to pull back the foreskin, stretch my penis and attempt to noose my bell-end, as is the method suggested in the manual. At least four pairs of hands are required for this exercise.
The foreskin inevitably creeps back and gets in the way, it is impossible to hold it back while tightening the noose.
I have learned the hard way that if you trap the foreskin under the noose and tighten you are in for an excruciating experience and some unsightly swelling that takes days to go down!
On the occasions that I do manage to get the positioning of the noose just right, without trapping any foreskin, unfortunately it is not long before the head slips out, painfully.
The noose is fastened tightly enough and the device is not over tensioned.
I have used the foam padding that comes with the kit. It does help to make it more comfortable but makes the device even more fiddly to use, instead of four pairs of hands six are now needed. It also does not last very long, in the two weeks I have had mine it is nearly all used up.
In the two weeks I have been using it I have noticed no gains unless you want to count the swelling caused by trapped skin!
I understand that two weeks might be too early to expect results.
Can anybody offer reasonable suggestions on how to make this device easier to put on, without trapping foreskin?
How can I stop my penis head from slipping out after only wearing it for a short time?